又一隻 Byebye

Hard disk health and reliability WARNING

Your hard disk WDC WD10EADS-00M2B0 with firmware 01.00A01 and serial WD-WCAV50069604 requires attention!
The average temperature for this hard disk model is 34°C (min=25°C max=45°C) and yours is 41°C.

Attribute Current Raw
Raw Read Error Rate 200 000000000000
Spin Up Time 137 0000000017F5
Start/Stop Count 100 000000000025
Reallocated Sector Count 200 000000000000
Seek Error Rate 200 000000000000
Power On Hours Count 60 0000000073AE
Spin Retry Count 100 000000000000
Calibration Retry Count 100 000000000000
Power Cycle Count 100 000000000023
Power Off Retract Count 200 000000000022
Load Cycle Count 1 000000384E5D
Reallocated Event Count 200 000000000000
Current Pending Sector 200 00000000006A
Offline Uncorrectable Sector Count 200 000000000059
Ultra DMA CRC Error Rate 200 000000000000
Write Error Rate 73 00000000638C

All the attributes of your hard disk are above the S.M.A.R.T. thresholds set by the manufacturer. This is good.

BLOCKING ISSUE : your hard disk has 106 pending sectors (this value is very large and your hard disk should be replaced). Those are sectors that couldn't be properly read and that the hard disk logic is waiting for a write operation to try to remap to a spare sector (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.

BLOCKING ISSUE : your hard disk has 89 offline uncorrectable sectors. Those are sectors that an offline scanning found as unreadable. Offline scanning is a process that can be automatically started by the hard disk logic when a long enough idle period is detected or that can be forced by some tool. Those unreadable sectors are identified and the hard disk logic is waiting for a write command that will overwrite them to try to remap them to spare sectors (if available). According to the Reallocated Sector Count attribute, your hard disk seems to have available spare sectors. A simple disk surface scan won't be enough to force the remap operation. You need a read/write surface scan to remap the sector. The best option should be a tool that knows about what should be read from that sector so that it has some option to apply the best fix to the missing data.

NOTE : your hard disk Power On Hours Count attribute current value (60) is below the normal range (91 - 100) reported for your specific hard disk model. Basically your hard disk was powered on for more than the maximum time the average user did. This means that either all of the reports collected are from hard disks that were not powered on for too long (this is realistic for recent models) or that your hard disk is becoming old. Usually this is not considered as a pre-failure advisory, but you should check whether you want to replace the hardware or keep an eye on its performances over time.

The overall fitness for this drive is 0%.
The overall performance for this drive is 100%.

收藏分享評分